Spring Engineers of Houston manufacture their AISI 1095 springs using high-quality steel. The springs are cold rolled and are available in annealed or tempered conditions. Suited for high stress flat springs and hot coiled rings, AISI 1095 steel is meant for high strength and hardness.
Spring Engineers of Houston provides AISI 1095 springs in the volumes our clients require. From prototypes and small runs to high-volume production, all delivered with fast delivery and fine service. We also offer comprehensive spring design services for both new and existing designs.
Contact our experts today to discuss your project.
Wire: No Strip: Yes Sheet/Plate: Yes
Material Type: AISI 1095
Material Group: Carbon Strip
| E Mpa | 207,000 | Min Size (in) | 0.003 |
| E psi | 30,000,000 | Max Size (in) | 0.125 |
| G Mpa | 79,300 | Min Size (mm) | 0.080 |
| G psi | 11,500,000 | Max Size (in) | 3.000 |
| Density g/cm3 | 7.860 | Surface Min | b |
| Density lb/in3 | 0.284 | Max Temp °C | 120 |
| Conductivity | 7 | Max Temp °F | 250 |
All materials specifications are provided for general reference purposes only.
| E Mpa | Young's Modulus | These factors can vary with cold work, heat treating and operational stress. | |
| E psi | |||
| G Mpa | Modulus of Rigidity | ||
| G psi | |||
| Conductivity | % IACS | ||
| Surface Min | Typical Surface Quality | a | Maximum defect depth: 0 to 0.5% of d or t |
| b | Maximum defect depth: 1.0% of d or t | ||
| c | Defect depth:less that 3.5% of d or t | ||
| Min Size | Sizes commonly available for wire or strip | Special sizes may be available at additional cost. | |
| Max Size | |||
| Max Temp | Maximum service temperature | May vary due to operating stress | |
