|
 Material Type: AISI 1065
Material Group: Carbon Strip
AISI 1065 Springs Description:
Pre-hardened material well suited for fabrication requiring shaping
by blanking, bending, drawing, extrusion and swaging. Allows for closer
dimensional tolerances and improved finish and available in several
grades. Grade selection is important when considering higher levels of
wear resistance.
Available AISI 1065 Springs Material Forms
Wire: No Strip: Yes Sheet/Plate: Yes
Engineering Data
| E Mpa |
207,000 |
Min Size (in) |
0.003 |
| E psi |
30,000,000 |
Max Size (in) |
0.125 |
| G Mpa |
79,300 |
Min Size (mm) |
0.080 |
| G psi |
11,500,000 |
Max Size (in) |
3.000 |
| Density g/cm3 |
7.860 |
Surface Min |
b |
| Density lb/in3 |
0.284 |
Max Temp °C |
95 |
| Conductivity |
7 |
Max Temp °F |
200 |
All materials specifications are provided for general reference purposes only. |
AISI 1065 Springs Application:
|
| E Mpa |
Young's
Modulus |
These factors can vary with cold work, heat treating and operational
stress. |
| E psi |
| G Mpa |
Modulus of
Rigidity |
| G psi |
| Conductivity |
% IACS |
| Surface
Min |
Typical
Surface Quality |
a |
Maximum defect depth:
0 to 0.5% of d or t |
| b |
Maximum defect depth:
1.0% of d or t |
| c |
Defect depth:less that
3.5% of d or t |
| Min Size |
Sizes
commonly available for wire or strip |
Special sizes may be available at additional cost. |
| Max Size |
| Max Temp |
Maximum service
temperature |
May vary
due to operating stress |
AISI 1065 Springs